Simulated workplaceCAQA Voltline Electrical is a fictional business created by CAQA for training and assessment. It is not a real company and no person, client or record here is real.About this simulation
UEECAQA VoltlineSimulated workplace
Simulated workplace
Scenario · Electrical Contracting

Verify tests and prepare the certificate for a new three phase supply

You are a licensed electrician in Electrical Contracting.

Intermediate2 to 3 hours8 tasks
Start the tasksAll scenarios
Home/Scenarios/Verify tests and prepare the certificate for a new three phase supply
The situation

What has happened

Job J-26-1147 at Fairmont Engineering Works in Geelong installed a new 63 A three phase supply and isolator for a CNC machine. The Leading Hand completed the tests on Friday and the compliance register shows the results as Tests recorded. The General Manager checks every prescribed work certificate before it is lodged and has asked for a review of the test sheet against the policy and procedure before he signs. The customer wants the machine running on Wednesday. The test sheet shows earth continuity, insulation resistance, polarity and fault loop impedance, but the residual current device test line is blank and the instrument identification is written as 'van tester'.

Your brief. Review the test results against the testing and certification policy and the installation testing procedure, identify what is missing or inadequate, arrange and record the outstanding tests, confirm the instrument and its calibration, complete the compliance register entry properly and prepare the certificate of electrical safety for the General Manager's check.
Read the work request in your inbox
Tasks

Deliverables

  • Completed test results and commissioning sheet with all mandatory tests and the instrument recorded
  • Updated compliance register entry
  • Draft certificate of electrical safety for checking
  • Note to the General Manager on the review findings

Documents to use

Systems to use

Test and Compliance Register

Records the mandatory test results, certificates of electrical safety, solar compliance documents and observations for every job before it is handed over.

Instrument, Plant and Vehicle Register

Tracks every test instrument, refrigerant recovery unit, scale, leak detector, ladder, elevated work platform and service van with its calibration or inspection status.

Job and Work Order Board

The record of every quoted, scheduled, in-progress and completed job across all departments, with the site, allocated tradespeople, supervising electrician and status.

For trainers and assessors

Units of competency

Current on training.gov.au for the Electrotechnology Training Package as at 10 September 2026.

UEEEL0039Design, install and verify compliance and functionality of general electrical installations
UEEEL0027Carry out low voltage electrical field testing and report findings
UEEEL0002Apply currency of safe working practices and compliance verification of electrical installations
UEECD0051Use drawings, diagrams, schedules, standards, codes and specifications

Qualifications

UEE30820Certificate III in Electrotechnology Electrician
UEE40320Certificate IV in Installation Inspection and Audits
Assessor notes

What to look for

Evidence guide

The student must identify the missing residual current device test and the inadequate instrument record, and must not accept a pass without measured values. Look for correct sequencing of tests, an instrument identification traced to the register with current calibration, and a certificate that matches the work and the recorded results. The note to the General Manager should be factual and brief.

The student's evidence summary lists every record they created or changed in the systems named above, their notes and the tasks they ticked. Verify it against the deliverables and your own assessment tool.